Master Bathroom Remodeling in Garden Grove, CA
Curbless showers, double vanities and custom tile for primary baths.
Master Bathroom Remodeling for Garden Grove Homes
Primary baths in 1950s and 1960s Garden Grove homes are usually small, tucked off a bedroom or hallway and often outfitted with a tub-shower combination and a single vanity. Homeowners want what newer houses offer: a curbless or low-curb shower, a double vanity, better lighting, a properly vented fan and storage that does not eat the room. Getting there in a tract house requires reconsidering walls, plumbing locations and, sometimes, borrowing space from a closet or hallway.
Plumbing on a slab foundation shapes design. Drains in the slab are costly to move, so we usually design around existing fixture locations or budget for slab cutting and re-pouring if a shower or toilet must move. A curbless shower requires a floor slope and, often, recessed framing or slab work. Original galvanized supply lines are common in houses of this age, and a bath remodel is a good time to replace them. If your house was built before 1994 and you pull a permit, the project must also bring non-compliant fixtures throughout the house up to water-conserving standards.
Moisture control and ventilation matter in any climate, and while ours is dry, showers are not. Waterproofing assemblies, exhaust fans vented to the outside and tile installation methods all determine whether the bath lasts. We plan electrical for GFCI protection and high-efficacy lighting, and we test for lead and asbestos in older finishes before demolition. The result is a bath that feels like a retreat and is built to last.
Garden Grove-Specific Considerations
- Slab foundations make relocating drains expensive, so layouts that keep the toilet and shower near existing drain lines save budget, while moves require cutting and patching concrete.
- Galvanized supply lines and old drain lines are common in homes from this era and are often replaced during a bath remodel when walls are open.
- Pre-1994 homes pulling a permit generally must replace non-compliant toilets, showerheads and faucets with water-conserving models before final approval.
- Bath exhaust fans must be vented to the outdoors, and routing through attics in single-story homes should be planned in advance.
- Older tile, mastic, vinyl flooring and textured ceilings may contain asbestos and paint may contain lead, so testing before demolition is prudent.
Our Master Bathroom Remodeling Process
1. Plan the layout around the plumbing
We measure the room, find the drains, and decide whether to keep fixtures in place or invest in slab work for a better layout.
2. Test and plan demolition
Pre-1978 finishes are tested for lead and asbestos, and demolition is planned accordingly, with proper containment if needed.
3. Rough-in and waterproofing
New supply, drains, vents, wiring and exhaust ducts are installed and inspected, then shower pans and waterproofing are built and tested.
4. Tile, glass and vanity
Tile is set over the waterproofing, glass is templated and fabricated after tile is complete, and the vanity and counters are installed.
5. Fixtures, trim and final inspection
Plumbing fixtures, lighting, mirrors and accessories are installed, and the city final inspection is scheduled, including checks of water-conserving fixtures where required.
Investment Range
- Mid-range: $45,000 – $70,000
- Custom high-end: $70,000 – $110,000
- Luxury full gut: $115,000 – $180,000+
Neighborhoods We Serve
Related Garden Grove Kitchen Remodeling Guides
Master Bathroom Remodeling FAQ — Garden Grove
Can I get a curbless shower in my Garden Grove home?
Often yes, but on a slab it may require cutting concrete or recessing the shower area to create slope for the drain. We evaluate your floor and framing before promising a design, and weigh the cost against a low-curb alternative.
Do I have to replace all fixtures in the house?
For houses built before 1994 that pull a building permit, California law generally requires non-compliant toilets, showerheads and faucets throughout the home to be replaced with water-conserving models as a condition of final approval. Confirm the current rules with your building department.
How long does a primary bath remodel take?
Often several weeks of construction after permits and materials are ready, with waterproofing and tile cure times as the pacing items. Custom glass is made after tile is complete, which adds time. We provide a schedule at the planning stage.